Webbing for Aluminum Lawn Chairs: A Step-by-Step Guide

When it comes to replacing the webbing on your aluminum lawn chairs, there are several things you can do to ensure a successful installation. In this article, we will provide a step-by-step guide on how to replace the webbing on your aluminum lawn chair.

Removing Old Webbing

Before you start, make sure to remove any old webbing from the chair. If the chair has a drooping seat or many frayed straps, it is best to remove all the webbing. However, if only one or two straps are torn and the rest look good, you may want to replace only them.

Measuring for New Webbing

To measure for new webbing, start by folding 3/4 inch (2 cm) of strap around a clip and inserting it into a slot. Screw in one end of the strap, pull it tightly, and screw in the other end. Make a hole with an awl or screw about 1/2 inch (12 mm) from the tip of the point.

Installing New Webbing

To install new webbing on your aluminum lawn chair, start by cutting a length of strap 1 inch (2.5 cm) shorter than your measurement. Fold down the corners at one end of the strap to form a point, and then loop the other end of the strap around the other side of the frame. Pull the strap tightly and attach it in the same manner.

Using Plastic Rivets

If you are using plastic rivets, make sure to drive them in with a rubber mallet or very gently with a hammer. This will ensure that they do not break off during installation.

Attaching Webbing to Frame

To attach the webbing to the frame of your aluminum lawn chair, start by making a hole about 1/4 inch (6 mm) from each end of the strap. Then, attach one end of the strap with a sheet-metal screw. This will ensure that you stretch the strap as tightly as possible when installing it.

Replacing the webbing on your aluminum lawn chair is a relatively simple process that can be completed in a few hours. By following these steps and using the correct materials, you should be able to install new webbing successfully. Remember to measure carefully, remove any old webbing before installing new, and use plastic rivets if necessary.

Additional Tips

* Make sure to take measurements for both the chair back and seat.

* Cut strips of webbing that are 2 inches (5 cm) longer than your measurement for horizontal straps with screws.

* Use a screwdriver or awl to make holes in the strap as needed.

* If you are using clips, add 1 1/2 inches (4 cm) to each measurement.

By following these tips and steps, you should be able to replace the webbing on your aluminum lawn chair successfully.

Webbing for aluminum lawn chairs